Brandon homes built from the 1980s through the 2000s often have side-by-side refrigerators with built-in ice makers that sit in unconditioned garages or utility rooms. The humid subtropical climate keeps indoor humidity high even in mild winters, so moisture collects on evaporator coils and creates ice dams that crack plastic housings and damage auger motors. Technicians see this most often in Providence Lakes and Regency Park where many original appliances are still in service.
Water supplied from Hillsborough County lines carries higher mineral content than Tampa city water, so inlet valves and fill tubes clog faster. In summer heat the ice maker runs longer cycles, which wears the mold heater and thermostat contacts. When a homeowner notices hollow cubes or slow production, the cause is usually a failing water inlet valve or a kinked line behind the refrigerator rather than the ice maker module itself.
Ice Maker Repair Near You — Choose Your City
Every city below has its own local Ice Maker Repair page with coverage details.
Older Brandon East properties frequently have refrigerators placed against exterior walls where temperature swings affect the ice maker’s thermostat. Replacing only the module without checking the fill tube and valve leaves the root problem untouched. A full repair includes verifying the saddle valve or refrigerator shut-off is not corroded and confirming the drain pan is clear so melt water does not refreeze on the floor.
Technician insight
In Brandon the thing that catches most people out with ice maker repair is the mineral scale from county water that builds up in the inlet valve during our long, humid summers. Homeowners replace the module only to have the same slow-fill problem return within weeks because the valve was never addressed.
Providence Lakes Side-by-Side
Homeowner reported no ice for three days. Inspection showed the fill tube frozen solid and the inlet valve solenoid stuck partially open. Replaced the valve, thawed the tube, and verified proper fill level. Unit produced full cubes within two hours and continued without further issues.
Ice Maker Repair Services We Offer
✓Ice Maker Module Replacement
Swap the complete ice maker assembly when the mold heater or ejector fails, restoring consistent cube production in refrigerators common to Brandon homes.
✓Water Inlet Valve Repair
Clean or replace the dual solenoid valve that controls water flow to the ice maker, addressing slow fill and mineral buildup from Hillsborough County water.
✓Frozen Fill Tube Thawing
Clear ice blockages in the fill tube caused by high summer humidity and repeated freeze-thaw cycles without damaging the tube or surrounding wiring.
✓Ice Maker Sensor Calibration
Adjust or replace the optical or mechanical sensor so the unit stops overfilling or underproducing cubes in side-by-side models found in Providence Lakes.
✓Auger Motor and Dispenser Repair
Service the auger motor and dispenser solenoid that push ice through the door chute, common wear items in homes near Brandon Town Center.
Ice Maker Repair Cost in Florida
| Service | Typical Range | What Affects It |
|---|---|---|
| Diagnostic Visit | $75–$125 | Applied toward repair when work is approved same day |
| Ice Maker Module Replacement | $225–$375 | Varies by refrigerator brand and whether the module is still available |
| Water Inlet Valve Replacement | $180–$320 | Includes new valve and any needed tubing |
| Fill Tube Clearing or Replacement | $125–$225 | Lower end when only thawing is required |
Ranges are typical for Florida and confirmed with an exact written quote before any work starts.
How it works
- 1
On-Site Diagnosis
Technician tests the ice maker cycle, checks water supply pressure, and inspects the fill tube and valve for mineral scale or kinks.
- 2
Parts Verification
Identify exact model-specific components needed and confirm availability before any disassembly.
- 3
Component Repair or Replacement
Replace the inlet valve, module, or clear the fill tube, then reseal connections to prevent leaks.
- 4
Cycle Test and Cleanup
Run multiple ice-making cycles, verify cube size and dispensing, and wipe down all surfaces.
Pricing
Most ice maker repairs in Brandon fall between $150 and $450 depending on parts required.